Intermediate step - black key
After pulling out the red key, insert the black key within 10 seconds and promptly turn
it to «
ON
». After 1-3 seconds, turn the key to "
OFF
" again and pull it out. In this way,
a maximum of 7 black keys can be programmed by repeating the above procedure
keeping the indicated times.
Final step - red key
After pulling out the last black key, insert the red key again and turn it to "
ON
" (this
operation should be performed within 10 seconds of pulling out the previous key).
Leave it in this position for 1 to 3 seconds and return it to the «
OFF
» position.
Proper programming check
Insert the red key disabling the transponder (i.e., tilt the key cap by 90°) and turn the
key to "
ON
". Perform the engine start-up operation. Ensure that the engine does not
start. Insert the black key and repeat the start-up operation. Check that engine starts.
WARNING
SHOULD THE ENGINE START WITH THE RED KEY (WITH TRANSPONDER OFF),
OR IN THE EVENT OF WRONG OPERATION DURING PROGRAMMING, REPEAT
THE PROCEDURE FROM THE BEGINNING.
01_18
Saddle opening remote control (01_18, 01_19)
The scooter is fitted with a remote control to open the saddle. This remote control is
supplied together with the keys and it has been programmed to control the opening
device control unit at the manufacturing stage. If the remote control is lost, a new one
can be requested and programmed at any
Authorised Service Centre
. The remote
control is powered by inner batteries that get discharged after extended used; If the
green LED turns on when the button is pressed, the remote control is working properly.
You may need to replace the batteries if the remote control fails or if its range of
operation is reduced. To separate the two halves of the remote control, insert the blade
of a plain slot screwdriver at one point on the edge and slide it all around. When the
remote control is open, remove the
two batteries
from the contact terminal. Install the
two new
CR1616 3V
batteries with the positive pole facing the contact terminal.
20
1 Vehicle
Summary of Contents for xevo 250IE
