28
PianoDisc Installation Guide
228CFX - PianoCD - iQ
Step 18:
Mount the sustain lever and pedal
solenoid
. . . a note about using the right equipment
When drilling the trapwork use a drill press to drill the holes accurately. Doing
this by hand is strongly discouraged since the tolerances are very critical,
sometimes less than a thousandth of an inch. There is very little room for error.
A.
Place the lyre back into its position on the piano.
B. Drill a hole through the sustain lever.
Using the diagram in figure 15, drill
a #20 (4 mm) hole through the sustain lever as indicated.
•
Tap in the pivot pin into the hole with a hammer (lubricate the hole with grease).
The pivot pin is supplied in the kit.
Figure 15
C. Mark the solenoid contact point.
Measurement 6” (152 mm) from the
pivot pin towards end of lever (See figure 16B).
Summary of Contents for PianoCD
