PianoDisc Installation Guide
73
. . . . .
Pedal Adjust Mode
After learning the piano, give the pedal solenoid the necessary amount of
power needed to strike and hold the pedal.
IMPORTANT
: See the
Technical Information Guide: SilentDrive System
to learn more
about why pedal adjustments are necessary and how to quantify adjustment values.
To select the Pedal Adjust mode:
1.
Rotate the Select wheel
(
+
)
or
(
-
)
until the
Learn LED
is illuminated.
• The
Status LED
remains dark.
2.
Push in and hold the Select wheel for approximately two seconds.
• The
Learn LED
flashes steadily.
• After two seconds, the
Status LED
illuminates (
green
).
3.
Release the Select wheel.
• The pedal starts to rise and fall.
• The initial pedal hold value is 0 and strike value is 50.
4.
You are now ready to raise or lower the pedal strike value.
To increase or decrease the Pedal Strike value:
1.
Rotate the Select wheel
(
+
)
to increase the value or
(
-
)
to lower the value:
• Hold the wheel in this position to adjust the pedal strike over several increments at a
time.
OR
• Rotate and release to adjust the pedal strike by increments of 5.
2.
After the
Pedal Strike Value
is adjusted, change the
Pedal Hold
adjustment:
• Push in and release the Select wheel.
• The
Learn LED
double flashes. An initial hold value of 30 has been set.
Summary of Contents for PianoCD
