Pic Solution GoClic, Owner'S Manual

9

3. 

Obtaining a blood sample (i)

Use the pre-set lancing device to puncture the desired site. The size of the drop should be at least 0.5 microliter 
(μL) of volume for glucose test. Gently squeeze the punctured area to obtain another drop of blood. Be careful 

NOT

 to smear the blood sample. 

4. 

Apply the sample (j)

Gently apply the drop of blood to the absorbent hole of the test strip at a tilted angle. 
Confirmation window should be completely filled if enough blood sample has been 
applied. Do 

NOT

 remove your finger until you hear a beep sound.

If the blood volume is insufficient, the triangle icon with exclamation mark will appear 
on the meter display to remind you to refill the second drop of blood to the same test 
strip within 3 seconds. 
If the blood volume is still underfill after the second drop of blood applying, E-3 error 
message will appear on the display with the triangle icon with exclamation mark.

NOTE:

•  Do not press the punctured site against the test strip or try to smear the blood.
•  If you do not apply a blood sample to the test strip within 3 minutes, the meter will automatically turn off. You 

must remove and reinsert the test strip to start a new test.

•  The confirmation window should be filled with blood before the meter begins to count down. If there is 

insufficient blood volume in the test strip confirmation window, you can apply second drop of blood to the 
same strip before countdown begins. The meter will display an “E-3” error message if there is still underfill, in 
which case 

discard the used test strip and retest with a new one

.

•  If you have trouble filling the confirmation window, please contact the consumers’ toll-free number for Italy 

800 900 080 and for France 01.55.93.26.48. for assistance.

5. 

Read Your Result

The result of your blood glucose test will appear after the meter counts 
down to 0. For result readings please refer to paragraph “Measurement Result 
Readings”. The blood glucose result will be stored in the memory automatically. 

6. 

Pull out the used test strip (k)

Pull out the used test strip. Use a sharp bin to dispose of used test strips. The 
meter will switch itself off automatically.

WARNING:

The used lancet and test strip may be biohazardous. Please discard them carefully according to your local 
regulations.