21
EN
TermalVap is a thermal inhaler equipped with a steel boiler inside of which a
230V electric heating element operates. The appliance generates hot steam which,
by way of a sprayer that takes advantage of the Venturi principle, is capable of mix-
ing the steam developed by its own boiler with the main thermal waters located
outside of the appliance.
Built with a high thermal insulation plastic body in conformity with European safety
standards, the appliance was designed for the inhalation of bottled thermal water
and is equipped with specific safety systems such as the double safety thermostat
applied on the boiler and the safety cap which is triggered when pressures greater
than 2 bar are reached.
The appliance in question should be used as an inhaler for household use.
GENERAL WARNINGS
CAREFULLY READ THE INSTRUCTION MANUAL BEFORE USING THE APPLI-
ANCE. NEVER DISASSEMBLE THE UNIT.
FOR ANY SERVICE CONTACT THE PIC TECHNICAL SERVICE CENTRE. NEVER
ALLOW CHILDREN AND / OR INCOMPETENT PEOPLE TO USE THE MEDICAL
APPLIANCE WITHOUT PROPER SUPERVISION BY AN ADULT IN FULL POS-
SESSION OF HIS OR HER MENTAL FACULTIES.
FUNDAMENTAL SAFETY STANDARDS
1. On opening the package ensure that the appliance is whole, taking particular
care that there is no damage to the plastic parts which may provide access to
the live internal parts of the appliance and ensure that there is no breakage and/
or peeling of the power cable. In these cases do not connect the electrical plug
and contact the PIC TECHNICAL SERVICE CENTRE.
2. Before connecting the unit always ensure that the electrical data indicated on
the silver plate (positioned on the bottom) and the type of plug used correspond
with those of the electrical mains you intend to connect to.
3. Before connecting the uni fill the boiler with 800ml of demineralised or distilled
water and ensure that there are no water leaks from the bottom of the unit.
Otherwise, do not use the appliance, and contact the PIC TECHNICAL SERVICE
CENTRE.
4. If there is a visible steam leak from the safety cap (which is an indicator of a mal-
function) switch off the appliance and contact the PIC TECHNICAL SERVICE CEN-
TRE. If the appliance does not generate steam after 10 minutes of being switched
on there has probably been a drop in power from the mains to which the ap-
