FILAMENT LOADING
33
When load is completed, a small
amount of filament comes out of the
nozzle. Remove it carefully from the
build plate.
Pull the filament feed tube through the guide hole and insert it into the PH against the
stop. Make sure that the tube is completely inside the printer and press the joystick.
In case the material is loaded into both nozzles, the printhead moves to the position
for loading it into the second (right) nozzle. To load the second material, repeat all the
steps from 5 to 12.
The printhead moves to the parking position: the far left corner. The filament loading is
completed.
11.
12.
13.
14.
Summary of Contents for Designer XL PRO
