PRINTING
36
Some X Platform features are inactive for tasks with extension .gcode, as such tasks were
created by third-party software.
When printing is completed, the printhead moves to the parking position; the build plate
lowers.
After printing wait for 15 - 20 minutes until the glass cools down. Lift the ejector(s) and
remove the glass together with the model out of the printer.
Use Polygon X software to prepare new print tasks. The current version of the software is
available on the official website.
Carefully take off the model from the glass.
If you can’t take off the model with your
hands, use the box cutter supplied with the
starter kit.
When the model is taken off install the
glass back into Designer XL PRO. Make
sure the glass is firmly fixed on the
platform: the far grooves is under clamps;
the central magnet is in the hole; there is
no air gap and there are no foreign objects
between the glass and platform.
Insert the nozzle change key into the
printed holder.
Do not take off the model from the
hot glass.
Do not use tough tools to take off
the model. This may cause damage
to the glass.
Hold the glass while removing it
with the printed model.
Summary of Contents for Designer XL PRO
