CONNECTION TO PC
9
39
To connect Designer XL PRO to a PC via network, insert an Ethernet cable both into
the Ethernet port of the 3D printer and into the corresponding port on the PC or on the
router.
Designer XL PRO and PC must be in one and the same LAN.
Next, follow the step-by-step instructions:
Select «Settings > Network settings» on the printer menu, enable «DHCP» to
automatically assign IP addresses or set the IP address manually. If DHCP is active, the
IP address is obtained within 2-5 minutes.
Select the «Network» tab on the «Settings > Appearance and Network > Network»
menu in Polygon X. Click «Search». Polygon X shows a list of all 3D printers connected
to this subnet.
Select «check box» next to the used 3D printers. Press «Close».
1.
2.
3.
9
The connection algorithm is in compliance with Polygon X software version 1.3 and with the printer
firmware version 5.209
Summary of Contents for Designer XL PRO
