OPERATING AND INSTALLATION MANUAL SURFACE-MOUNTED UNIT LG 100 AP
PAGE 11
Changes reserved
5.5. Plant operation
B
Operation of the ventilation unit is permitted only if all built-in parts provided e.g. silencers etc., have been properly
connected
B
In the event of any errors or defects that can cause harm to persons or property, the system must be put out of
operation immediately. Further use must be actively prevented until the unit is fully repaired.
7. Design of the ventilation unit
The compact ventilation unit LG 100 comprises:
•
a compact, thermally insulated and soundproof EPP housing
•
a casing of galvanised steel sheet, powder-coated in RAL 9003
•
a design front that comes with an outside powder coating in RAL 9003 as a standard
•
a highly efficient enthalpy exchanger
•
energy-saving EC radial fans
•
an integrated sensor system for measuring the volumetric flow, temperature, relative humidity and VOC/eCO2 concentration
•
outdoor air and extract air filter ISO Coarse 70 % and supply air filter ISO ePM1 55 %
•
an integrated filter monitoring function - when the time interval is reached
•
standard operation via pushbutton on the unit, WLAN interface for controlling the PICHLER-APP and for providing remote access
via PICHLER Connect, and optionally with the “MINI” control unit for setting the basic functions.
6. Customer service
J. Pichler Gesellschaft m.b.H.
9021 KLAGENFURT
Karlweg 5, Postfach 32
T
+43 (0)463 32769
Please contact the installer of your ventilation and air conditioning system or contact us directly for any questions relating to the
delivered compact ventilation unit LG 100.
If error messages are output or in the case of damage, the ventilation unit must be switched off and disconnected from the mains
immediately. Ensure that you are safety conscious and aware of risks when you open the unit and when you remove cover plates. Any
work practices that could potentially impair the safety of the unit are prohibited.
The compact ventilation unit may be operated only in accordance with the project documentation. which shall comply with the
Equipment and Product Safety Act and the pertinent provisions of the EC Directives and Standards. Consider environmental impacts
and refrain from installing the ventilation unit in the vicinity of flammable liquids or gases, in swimming pools or in areas exposed to
chemicals or hazardous substances. Never operate the ventilation unit without an air filter. Air filters must be checked regularly for
dirt and damage and replaced, if necessary. The air filters must be changed at least every six months or when the “Change Filter”
message appears on the control unit. Use original replacement filters only. If the plant is not used in summer, the air filters must, for
hygienic reasons, be replaced prior to restarting.
Comply with safety requirements and standards when operating the ventilation unit simultaneously with ambient air-dependent
fireplaces. When using fireplaces dependent on ambient air, combustion air supply must be provided separately. Due to the heavy
load as well as the irregular operation, extractor hoods must in no case be integrated into the exhaust duct of the compact ventilation
unit. Exhaust air extractor hoods must be operated via separate air pips with suitable air replenishment e.g. by means of window
ventilation or in air recirculation mode. For corresponding details see Sections 4.1.1. and 4.1.2.
GENERAL
USER
SPECIALIS
T PERSONNEL
B
Operation of the unit is exclusively permissible with a connected air duct or mounted system components such as
silencers, in order to ensure that, for example, fans or electrical installation parts, cannot be touched with the hand.
