F860
7
Rev. 11/05
Ph: 800-421-6511
www.picomacom.com
Installation
Signal Combining Methods
The output levels of the modulator should be the same as the output of the off-air strip amplifiers. The
F860
modulators are usually
combined with either the
DSP806
channel processors, or
XBS
series strip amplifiers. Three methods are suggested to combine strip
amplifier, modulator and processor outputs.
The
C860
twenty-four channel combiner consists of two rows of directional couplers combined by a hybrid splitter. The directional
coupler combining provides high isolation (>40 dB) between the inputs. Normally, the odd channels are combined on one row while
even channels are combined on the other row of directional couplers. The combiner loss is 28-30 dB per channel. Used with an
L860
distribution/launch amplifier the system’s RF output provides high quality, distortion-free programming.
The
CHC-16U/860
provides both signal combining and post-amplification of the headend signals. Up to 16 channels may be com-
bined using the
CHC-16U/860
. The combiner gain is 15 dB per channel.
The final method of combining signals uses three hybrid splitters per headend rack. The odd channels are combined in one splitter,
the even channels in another splitter and the two splitters are combined to a single output with a third splitter. Each rack is then
combined with a final splitter prior to the
CA-30RK1000
or
L860
post amplifier.
F860 Manual.qxd 11/21/05 10:17 AM Page 7
