PICO MACOM INC.
12500 Foothill Blvd. • Lakeview Terrace, CA 91342 • (818) 897-0028 • (800) 421-6511 • FAX (818)824-7197
P A N E L S
Front and Rear Panels
4
1.
Power on LED:
Indicates power is on when lit.
2.
Video/Audio Ratio adjustment:
Used to set level of audio carrier.
3.
Audio Modulation LED:
Indicates aural over modulation level
when lit.
4.
Audio Modulation adjustment:
Used to set audio modulation (Volume).
5.
Video Modulation adjustment:
Used to set video modulation.
6.
Video modulation LED:
Indicates video over-modulation when lit.
7.
Channel Select:
Dip switches are used to select desired
channel.
8.
RF Output Adjust:
Used to set output level.
9.
-30dB Output test monitor:
Used to monitor RF output level.
10.
RF Output:
Connect this port to distribution system.
11.
I.F. Input:
Input from I.F. scrambler or I.F. output.
12.
I.F.Output:
To I.F. input or to scrambling device.
13.
Video Input:
Accepts video output from satellite
receiver, VCR and CCTV camera.
14.
Audio Input:
Accepts audio output from satellite
receiver, VCR and CCTV camera.
15.
SUB CATV:
When switch is in SUB position channels 7
to 13 are converted to T7 to T13. When
switch is in CATV position CATV channels
2 to 78 and 95 to 99 are available.
16.
Fuse holder:
117VAC type - 0.5 amp, 125V slow-blow
fuse.
220VAC type - 0.5 amp, 250V slow-blow fuse.
17.
Convenience Outlet:
117VAC type - shown
220VAC type - 2 flat blade type (not shown)
18.
Power Cord:
117VAC type - Three wire, standard U.S.A. type.
220VAC type - Two wire,2 flat blade type.
CAUTION: FOR CONTINUED PROTECTION AGAINST
FIRE HAZARD REPLACE ONLY WITH THE SAME
TYPE 1/2 A 125 V FUSE AND RATING OF FUSE.
PFAM 550SUB
AGILE VIDEO MODULATOR
AUDIO
MODULATION
AURAL
LEVEL
ADJUST
VIDEO
MODULATION
ADJUST
OUTPUT
LEVEL
-30 dB
TEST POINT
RF OUT
IF
IF OUT
VIDEO
IN
AUDIO
IN
250 VAC
0.5A
600VA MAX
117VAC
60 Hz 20 W
FUSE
1
2
3
4
5 6
CHANNEL
8
9
7
10
11
13
14
15
17
SUB CATV
16
12
