3. Open a web browser and navigate to the following address: 192.168.4.1
4. Enter the network name and password for your home WiFi network. When you are done,
click the ‘Submit’ button.
5. Your PicoStill will validate the credentials you provided. Within a couple of minutes, the
PicoStill’s LED will either show a solid green light or will blink red then yellow. If it is blinking red
then yellow, your credentials were incorrect. Press the power button and return to step 1. If it
is solid green, continue.
6. The PicoStill’s WiFi is now turned on. Repeat steps 2 and 3 above to connect with PicoStill
and open the PicoStill’s web interface.
7. On the PicoStill interface, you will see your WiFi network name, an IP Address, and a Connect
button. Copy the IP Address given on the web page, then click the “Connect” button.
8. Your PicoStill is now connecting to your home WiFi network. On your device, reconnect to
your home WiFi network.
9. Open a browser and paste or type the IP Address you copied in step 7 into the address bar
and hit Enter. You will see the PicoStill Data Page, which contains instructions for setting up
PicoStill, program control, utilities, and information about your PicoStill.
After physically connecting PicoStill to your Zymatic, you will use PicoStill’s Data Page to start
and stop programs, control your PicoStill’s fan, and monitor data from your distilling session.
For detailed instructions on using PicoStill, refer to the online PicoStill user manual.
You are now ready to start distilling with PicoStill!
PicoStill Ready
Your PicoStill is ready, begin the PicoStill process on your Pico or Z.
Updating Firmware
Your PicoStill is updating its firmware. Allow this to complete before trying to operate your
PicoStill.
