My vacuum is above 4 PSI ->
Go To ‘Checking for Vacuum Leaks’
My T2 keeps going above 95°F ->
Go To ‘My Pico or Z is displaying 'Remove Plug'
Checking for Vacuum Leaks
This information can be found in the Troubleshooting section of your PicoStill User Manual.
Check PicoStill's pressure seal During normal operation, the vacuum pump on your PicoStill
should hold internal pressure at 4 PSI or below. It may take 5-7 minutes for PicoStill to drop
internal pressure to this level. If internal pressure does not drop below this level after this
period, then there may be a pressure leak somewhere in the system. To avoid pressure leaks,
ensure that your PicoStill is completely assembled and that all components are seated
correctly.
Pressure leak testing procedure:
