5
AVAILABLE SIZES & POWER SOURCES
The Smart Cutter is a fine tuning tool. It can be used to fine tune remaining edges after a
connection has been reinstated using the Twister tools. The Smart Cutter can also be
used to remove any remaining lining or inconsistencies, after the collapsed lining has
been removed using a Smart Crusher, Sweeper or Chains. The side grinding panels adapt
to the pipe size when the tool rotates. A Drill Head can be used if needed.
Selecting the correct Smart Cutter for the job
Choose your Smart Cutter according to the size of the original host pipe.
SMART CUTTER
Shaft size
mm/inches
BEND 90°
BEND 45°
Smart Cutter DN100 /
4”
18 / ¾
”
YES
YES
Smart Cutter DN150 /
6”
18 / ¾
”
YES
YES
Smart Cutter DN200
-
DN300 /
8”
-
12”
18 / ¾
”
YES
YES
CHOOSING YOUR POWER SOURCE
The Smart Cutter for the 18mm/¾
”
diameter shaft has been designed for and can ONLY
be operated with the
Picote Maxi Miller Power+
machine.
The machine should only be connected only to a
380
-
480 Volt (3
-
phase)
power supp-
ly. The power source has to be grounded (earthed).
CHOOSING YOUR DRILL HEAD
The Smart Cutter can be used with or without the Drill or Crusher Heads by adding a Hub
Disc. The Drill Head and the Crusher are used when removing a deformed or collapsed
lining.
If access is restricted due to the failed or collapsed lining, the Smart Cutter might not fit
in with the Drill Head attached. In this case, the Drill Head may be replaced with a Hub
Disc. Without the Drill Head all the force is applied to the side grinding panels. The side
grinding panels will remove the remaining lining from pipe walls as required
