Picote Maxi Miller Power+ 18/18
VOLTAGE & POWER SUPPLY
Ensure that the supply voltage is correct
. The voltage of the power source must be within the voltage
range given on the nameplate of the machine.
The machine should be connected only to a
380
-
480 V power supply
as indicated on the nameplate,
and can only be operated on three
-
phase AC supply rated for at least
16 A current
. The machine has
been double sealed according to European standards.
The power source has to be grounded.
The fre-
quency transformer of the motor can cause residual current device to go off. If this happens frequently, change
the power source to one with slower residual current device.
Residual current device should be type A
and resid-
ual current permission should be
30 mA.
Use only residual current devices which are permitted in power feed
from main power source.
SAFETY FEATURES
There is a safety gear with a Lock/Emergency Stop Button on the machine
. The power supply to the
motor is cut off when the Emergency Stop Button is pushed. Always make sure the Emergency Stop
Button is pressed or completely unplug the machine when the machine accessories (e.g. Cutter or Grind-
ing Chains) are not inside the drain. An additional on/off switch is located in the main frame of the ma-
chine for increased safety of operation.
The machine has an operator presence control or
‘
OPC
’
. When the control is not held down, the machine stops.
OPC is the most important safety device of the Miller machines. Never place anything on the place of a foot (for
example a brick).
Power plugs
For safety purposes
, this machine may be equipped with a specialty plug. If the plug does not fit securely or match
the outlet, do not force it —
contact an electrician to determine the required power supply. Never alter the plug in
any way. Use the plug with an extension cord only if it can be fully inserted into the cord
’
s socket. Use the Maxi
Miller Power Plus with a heavy duty extension cord only. Extension cord
lead minimum thickness is 2.5 mm
2
/ 12
AWG
up to 10 m
.
If a power generator is used, make sure that power rating is sufficient,
at least 8 kVA
measured, continuous out-
put. Only clean and stabile sine wave is accepted. Contact your reseller or Picote Solutions technical support for
more information.
400 V
The Maxi Miller Power Plus is equipped with
a 5
-
pin 400 V / 16 A plug. The plug fits into a three
-
phase 400 V socket shown in the picture on the left.
Power cable lead minimum thickness 2.5 mm
2
/ 12
AWG.
The Maxi Miller Power Plus must be supplied with
sufficient power and proper current rating. Minimum
lead thickness for an extension cord is 2.5 mm
2
/ 12
AWG.
If power generator is used, minimum of 8 kVA is
required. An adapter is provided to connect the Maxi
Miller Power Plus into a 5
-
pin 400 V / 32 A socket.
Other adapters may be necessary for generator
connections.
11
The machine has an automatic safety clutch
which shuts down the machine when the tools get stuck.
12
Picote Solutions Oy Ltd www.picotesolutions.com
