English
23
If the period of stimulation is changed in the
‘F’
type of operation,
the whole period of stimulation will be changed. In this case, it will
be possible to change the time in 6-minute steps. The whole period
of the individual sequences must be divided by 6, to ascertain the
length of the individual sequences.
After processing the last parameter, press the
key again, to store
the new program. This will be confirmed by a signal tone. Now, the
symbol
‘U’
will appear in front of the program number in the display
unit (Figure 7). If no parameters have been changed, no User
program will have been determined.
The program numbers of the User programs have two digits. The
first digit indicates the program from which the User program has
been derived. The relevant User program will then also have the
impulse shape and type of operation of this program. The second
digit is a serial number.
Three User programs can be set up from each program.
Example:
User Programs from Program 1
U10 U11 U12
Deleting All User Programs
If you hold down the
and left keys when switching on the
device, all User programs will be deleted.
Deleting a Single User Program
Please choose the relevant User program in editing mode and
operate the
key, to delete one User program. The ‘U’ user
symbol will flash. The selected User program will be deleted by
operating the
key. This will be confirmed by a signal tone.
Switching the Signal Tones On and Off
Start the device in editing mode. To do this, also operate the
key
as well, while you are switching on the device. An
‘E’
will appear
top right in front of the display of the type of operation.
Operate the
key again. The
‘P’
or the
‘U’
in front of the program
number will flash. The signal tones will be switched on or off by
prolonged operation of the
keys.
‘SOU OFF’
or
‘SOU ON’
will appear in the display unit (Figure 8). This will be confirmed by
a signal tone.
Figure 7
Figure 8
