60
In programme 13-16 is reached the edit mode for the pulse width by pressing
the [
E
] key. The impulse width is blinking. By pressing the left [
▲
] key, the pulse
width is expanded by 5 µs (max. 300 µs).
By pressing the left [
▼
] key the pulse width is diminished by 5 µs (min. 75 µs).
By pushing the [
E
] or the [ • ] key the set parameters are stored and the edit
mode is left.
The PierenPlus basic switches OFF, if no key is pressed for more than 2 minutes. In
this case, no new settings are stored.
By pushing the [
E
] key again it is possible to edit the therapy time.
Storing and Memorizing/Recall the operating parameters
By pushing and holding the [
E
] key for 3 seconds, the date/time mode is reached.
By simultaneous pressing and holding of the left [
▼
] key and the [
E
] key for 3
seconds, the memory request mode is reached.
Date/Time mode
The LCD display shows two figures. The left number is the date; the right figure
is the time. By pressing the left [
▲
] key, the date is pushed forward by one day
(max. 30). By pressing the left [
▼
] key the date is diminished by one day (min. 1).
By pressing the right [
▲
] key the time is pushed forward by one hour (min. 0). By
pressing the [ • ] key the set parameters are stored, and the date/time mode is left.
Date and time are counted continuously. The PierenPlus basic is switched OFF
automatically, if not key is pressed for more than 2 minutes, thereby no new
settings are stored.
Memory Recall Mode
If no data is stored in your PierenPlus basic memory, ZERO/NULL will appear on
the LCD for two seconds. The device returns to the Ready mode. The LCD, however,
shall always show the operating parameters of the last session (see picture).
Pierenkemper Operating Manual - PierenPlus basic
