User Instruction - Pointoselect digital
5
After 2 minutes of no use (measurement or stimulation) the device switches
off automatically.
If the hand probe is not correctly connected to the Pointoselect digital, „no HS“
appears in the display (see illustration left).
Mode selection
The button is used to switch between the following operating modes:
Automatic measurement
Manual measurement
Stimulation
Displays stimulation settings and adjustments
The
button is used to switch between body mode and ear mode. These op-
tions can only be selected in „automatic measurement“ and „manual measure-
ment“ operating modes.
Ear
Ear-Gold
Only gold points are detected and displayed.
Ear-Silver
Only silver points are detected and displayed.
Body
IMPORTANT!
In „body“ mode only the inner sensor is analysed. The gold/
silver detection ist not active and therefore not shown in the display.
Measurement
Automatic
In automatic mode the inner and outer sensors of the hand probe continuously
take measurements.
The reference voltage changes automatically. It is displayed through a bar read-
out and a respective number below.
Each degree of sensitivity is related to a certain tone pitch.
M
auto
M
man
S
Go
Si
