User Instruction - Pointoselect digital
6
Manual
When this operating mode is selected, the inner and outer sensors of the hand
probe continuously take measurements.
The reference voltage can be changed in 16 stages using the left / keys on
the device console or the / keys on the hand probe. The modified reference
voltage is shown by the bar readout and by the number at the bottom right of
the display. A specific signal tone pitch level is assigned to each reference
voltage value. If the reference voltage is lower than the values measured by
the inner and outer sensors the signal tone stops.
Gold/silver detection
When a gold point is detected „Go“ appears in the display and the green LEDs
on the hand probe light up. The signal tone is continuously.
When a silver point is detected „Si“ appears in the display and the yellow LEDs
on the hand probe light up. The signal tone sounds with a frequency of 2 Hz.
On Ear-Gold modulation, only gold points will be detected and displayed.
On Ear-Silver modulation, only silver points will be detected and displayed.
Attention!
On „Body“ modulation, only the inner sensor of the Pointoselect digital is
operating. No Gold/Silver-detection is completed or displayed.
Stimulation
Stimulation can be carried out in every operating mode
When pressing the button on the hand probe, the probe stimulates between
the inner and outer sensors according to the selected stimulation settings.
The letter „S“, the intensity and the frequency appear in the display (see
illustration) and the red LED at the hand probe will light up.
The intensity can be modified during stimulation using the left
/ keys on
the device console or the
/ keys on the hand probe.
The frequency can be modified during stimulation using the right
/ keys
on the device console.
Adjusting the stimulation settings
The stimulation settings can only be modified in the „Stimulation“ operating
mode. An overview appears in the display showing the selected intensity ,
frequency range and frequency (see illustration). To adjust the stimulation
setting intensity, press the
button.
