User Instruction - Pointoselect digital
8
Adjusting the volume
of the signal tone
To adjust the volume, press the button and the left
button on the de-
vice console when the device is starting up. The display screen shown left
appears.
The volume can be set to the desired value from 0-8 using the left
/ but-
tons on the device console. The signal tone is switched off entirely at „0“. In
this case the following symbol appears in the display: Signal tone
deactivated
Switching the device off
Press the
button to switch off the device.
If the battery voltage falls below the critical value or the device detects no
valid measurements over a two-minute period and no stimulation is started,
the device switches off itself.
Battery change
During operation, the voltage of the battery is shown by the segments inside
the battery symbol. If the voltage falls below the critical value, the Pointoselect
digital switches off itself and/or cannot be switched on again. A new 9 V bat-
tery (e.g. Type 6LR61) must be inserted into the device.
·
Switch off the device.
·
Open the battery compartment.
·
Remove the used battery from the battery compartment.
·
Insert a new battery according to the diagram. When inserting the new bat-
tery check the polarity. A protective circuit protects the device from damage
caused by connecting the battery incorrectly.
·
Close the battery compartment.
Always remove the battery if the device will not be used for a long period of
time.
If rechargeable batteries are used, follow the instruction manual of the battery
charger.
Used batteries must be returned to retailers or community collection points as
per the battery usage regulations.
