TPP
INSTRUCTION MANUAL
Page 10
Date rev. 28/05/13
Rev. 07
-
TS-6000
Cut & Press blades, for blocking the leads of the component on the PCB. (Max cut 1.3 mm).
Special blades suitable for your purposes are produced at request!
5.
USING THE TOOL
Before using this device, read carefully Chapter 1 (Safety Symbols and Rules to
observe).
Warning!
Always wear protective glasses during the use of the tool and do not
work with your fingers close to the blades while moving.
Warning!
After using, put device in a safety place and disconnect compressed
air supply system.
The tool should be used at the angle shown in the figures with respect to the working surface.
Fig. 11 – TP-6000
Fig. 10 – TS-6000