Pifco BHFP51001, Manual

8

Customer support team:

 +44 (0) 333 220 6054

NOTE:

Ensure the blades rotate unimpeded 

and do not graze against the back guard. If the 
fan blades become stuck or graze against the 
guard mesh, they will need to be re-installed. 
Repeat the steps above as necessary until the 
blades move freely and naturally inside the 
guard mesh.

Installing the Front Guard:

1. 

When the blades have been installed, 
connect the front guard to the back 
guard to complete fan assembly. To do 
this, align the edges of the two guards, 
ensuring the fixing bracket on the front 
guard is at the top of the fan, directly 
above the blades.

2. 

When the front guard is in place, locate 
the locking clips around the rim of the 
front guard and push each of these down 
to secure the front guard into place.

3. 

Use the screwdriver to fix the screw and 
lock nut through the hole in the bottom 
of the grill.

4. 

Your fan is now ready for normal use.

Using your appliance:

1. 

Press any of the 3 speed buttons on the 
fan’s control panel to turn the unit on. 
The fan will automatically start operating 
at the desired speed.

2. 

Press the 0 button on the fan’s control 
panel while it is in operation to turn the 
unit off.

Speed Selection:

This fan is equipped with a choice of 3 speed 
settings:
1 =  

Minimum

2 =  

Medium

3 = 

High

1. 

Press the corresponding button on the 
unit’s control panel to select the desired 
speed.

CAUTION:

 Press only one of the speed control 

buttons at a time. Permanent damage to the 
switch housing may result if two or more of 
the buttons are pressed simultaneously.

2. 

Press any of the other speed buttons 
while the unit is in operation to change 
wind speed. The fan will automatically 
adjust to the new setting within a few 
seconds.

3. 

Press the 0 button on the fan’s control 
panel while it is in operation to turn the 
unit off. Wind will stop emitting from 
the fan grille and the fan blades will stop 
rotating after a few seconds to show the 
unit has been turned off. 

Note:

Make sure that the fan is on a level 
surface and away from any liquids.

Oscillating the fan will create a more 
uniform cooling effect in the room.