Pifco P28053, Manual

7

www.pifco.co

Assembly and disassembly of the 

vacuum tube:

1. 

To assemble, insert the vacuum tube into 
the air intake opening. Push the vacuum 
tube in until it locks in place .

2. 

To disassemble, disconnecting the 
appliance from the mains socket.

3. 

Press the lugs either side of the 
connector and remove the vacuum tube.

Assembling the telescope tube and 

accessories:

1. 

Remove the telescope tube from the 
hand grip.

2. 

Set the telescope tube to the correct 
length.

3. 

Push the telescope tube slider forwards 
and pull out the lower part of the tube to 
the length required. Then simply let go of 
the slider and let it snap into place

4. 

Fix the floor brush to the telescope tube.

Floor brush settings:

The floor brush has 2 height settings.
•  Hard floors  =   Brush bar extended 
•  Carpets  

=   Brush bar retracted

Using your appliance:

1. 

Before using the appliance first roll out a 
sufficient length of electric flex cable and 
then plug into the mains socket.

2. 

The yellow mark on the electric flex cable 
is the maximum length that can be safely 
used and must not be exceeded.

3. 

To switch on the device press the foot 
pedal button   on the casing with your 
foot.

4. 

To rewind the power cable, press the 
button   with one hand and guide the 
cable with the other hand to ensure that 
it does not whip causing damage.

Adjustable power feature:

This cleaner has an adjustable power 
feature, enabling you to increase or decrease 
the vacuum power according to your 
requirements.

Note:

The vacuum cleaner comes with the 
following accessories;
•  A crevice tool to vacuum corners or 

narrow gaps.

•  A brush tool to clean delicate 

surfaces.

Note:

The vacuum is suitable for everyday 
cleaning of the carpet and of wooden 
floors.