1)
Filling the Water Tank.
CAUTION
Make sure that the Steam Mop is unplugged.
Turn the Water Tank cap counter—clockwise approximately 90
o
to the “OPEN”,
position and remove the cap as illustrated in Fig. 1 a, b and c.
Hold the mop at a 45
o
angle as illustrated in Fig. 1d and add water in the tank up to
the MAX level by using the measuring cup. Do not overfill. The maximum tank
capacity is 400 ML/13.5 OZ.
Replace the Water Tank cap and turn clockwise approximately 90
o
to the ”
CLOSE
”
position until the cap is tightened securely.
The Steam Mop uses tap water. However, in areas with hard water, distilled water
should be used for better performance.
Make sure the Copper Cone inside the Water Tank is always submerged in water
(as illustrated in Fig 1i ) while operating the Steam Mop.
NOTICE
Never put cleaning detergents or scented products into the Steam Mop.
This will make operation unsafe and damage the unit.
2)
Select the Steam Regulator positions:
There are 4 settings
1 - Low, 2 – Medium, 3 - High and 4 - Hot Spray
•1
- Low Ideal for cleaning all hard floors, such as linoleum, ceramic, marble, wood,
•2
- Medium Ideal for cleaning all hard floors, such as linoleum, ceramic, marble,
wood,
•3 - High Setting is Ideal for cleaning carpets and rugs.
•4 - Hot Spray Setting is Ideal for cleaning bathrooms,
kitchens. window sills, car wheels, etc.
You can change the Steam Regulator position and change
the steam output while operating the Steam Mop.
3)Once the unit has been fully assembled and filled with water, plug in the Power
Cord to a grounded electrical outlet. The RED light - Power Indicator will indicate
when power is on. Power Switch (O/I) is in the OFF (O) position (higher position).
Wait for the Ready to Use indicator to turn Green - approximately 20 - 30 seconds.
GREEN light will turn on when the steam mop is ready for use.
When the Ready – to - Use indicator light turns Green press the Power Switch (O/I)
to the ON (I) position (lower position).The mop will start emitting steam.
To stop emitting steam turn OFF (O) the unit by pressing the Power Switch (O/I)
again.
If the Power Switch (O/I) is pressed (lower position) prior to Ready – to – Use light
indicator turning green, water from the previous use will not be heated and will be
forced out by present steam and will cause puddling to occur.
This may also happen if the Power Switch was left in the ON (I) position (lower
position) from the previous use and the unit was disconnected by unplugging only.
Make sure to turn the unit OFF after each usage and then disconnect from
the electrical outlet so the unit is in the OFF (O) position when used next time.
4)Slowly pass over the surface to be cleaned. The absorbent mop cloth picks up the
dirt loosened by the steam. Apply steam liberally. Keep a towel handy and wipe away
any excess water that may accumulate.
5)When the Steam Mop stops emitting steam, simply turn OFF and unplug the appli-
ance, refill the Water Tank and continue cleaning.
