7
www.pifco.co
Assembly of your fan:
Before using, there is some assembly required
as follows:
1. Remove the cable tie and unravel the
power cord.
2. Lay the tower fan on a flat surface.
3. Place the two half bases together to form
a circle, ensuring that the power cord is
running through the hole.
4. Then put the whole of the base on the
bottom of the product, ensuring the power
cord slides into the notched area to prevent
the unit from resting on the cable.
5. Connect the main body to the base by
using the locking nut provided. The locking
nut is a circular part which screws onto
the grooved locking mechanism on the
underside of the base. Before assembling
the base, remove this nut by rotating it
counter-clockwise (to the left) until it
comes loose from the main body of the
fan, then sliding it down the power cable to
remove it.
6. Reverse this process after the base is
assembled and rotate the locking nut
clockwise (to the right) to secure the base
into place.
NOTE:
Ensure the power cord is threaded
through before securing the fan base. Press the
power cord into the line section so that the base
is flat to floor when in the upright position.
7. Turn the fan over and stand on its base.
8. The fan is now ready to use.
CAUTION:
Ensure the product is fully assembled
before plugging it into an electrical outlet.
Using your appliance:
This tower fan is equipped with three speeds and
smooth oscillation. To use the fan, follow the simple
instructions below.
•
Place the fan on a dry, level surface where it
will not overturn during use.
•
Make sure the SPEED CONTROL dial at the
top of the motor housing is in the [ OFF ]
position, then insert the power plug into a
220-240V 50Hz electrical outlet.
•
SPEED SELECTION:
The power switch is incorporated in the SPEED
CONTROL dial at the top of the fan’s motor housing.
Turn the switch clockwise from the OFF [ 0 ]
position to the desired speed setting for low,
medium or high speed.
1 = MINIMUM
2 = MEDIUM
3 = HIGH
1
3
2
