6
A long press of the Tempo switch enters Preset Select mode. Once you have entered the Preset
Select mode, the currently selected red preset LED will blink. A short press on the Tap Tempo switch
will move up one preset and a long press will move down one preset. Once the desired preset is
queued, pressing the Engage foot switch will activate it. When the footswitch is used to load a preset,
the bypass status of the effect will not change.
Presets:
The 4 LEDs above the Engage footswitch indicate which preset is currently selected. Pressing the
push button switch above the Engage switch cycles through the 4 available presets. When a new
preset is selected, the corresponding LED will blink. Press and hold the push button switch (or hit
the Engage footswitch) to load the selected preset. To save a preset after making changes, press
and hold the push button switch. This action will cause the current preset LED to double-blink. If you
want to save to over the current preset, press and hold the push button switch to save. If you want
to save to a different preset, press the push button switch until the desired LED is double blinking.
Then press and hold the push button switch to save. If you want to exit the preset save without saving
anything, press either the Engage footswitch or Tempo footswitch.
The Tempo footswitch can be assigned to perform alternate, Special FX functions by pressing the
push button switch located above the Tempo footswitch. Pressing the small push button switch will
cycle through the alternate footswitch functions. Once the desired function is selected, pressing
the Tempo footswitch will turn this function on and off. When a Special FX function is activated,
the corresponding LED will flash. Once a Special FX function is activated, you can still change the
functionality of the Tempo footswitch by pressing the push button switch.
Reverse makes the delay line go backwards.
Jump makes the delay line jump up 1 octave. When Jump is activated, only the first tap will change
pitch. If the second tap is turned on, it will remain at the normal pitch.
Pong is activated independently with a push and hold on the small push button switch. Pong causes
the echoes to alternate between the left and right channels and is meant to be used with a stereo,
two amp setup. The Pong function can be turned on and off regardless of which function is selected
for the Tempo footswitch. Pong cannot be activated by the Tempo footswitch.
Preset Select
Special FX
The primary function of the left footswitch is tap tempo. Pressing Tap sets the length of the delay
and overrides the current Time knob setting. Turning the Time knob overrides the tap tempo setting.
Tempo Footswitch
