CHAPTER 3. INFINITY RULES
19
3.6
Erase
To erase a loop, press and hold down the Stop footswitch.
If a loop is
stopped and armed
, pressing the
Undo remote switch
will
erase that loop.
When the
erase command is triggered
, the Stop LED, the current Arm
LED and the Multi-Segment Digit will
flash once
to indicate audio
has just been erased.
The Erase function is tied to the Arm/All settings (see page 8).
3.7
Overdub
Overdub lets you add additional material to the original loop.
Pressing the Loop footswitch
when a loop is playing back will start
overdubbing
. The corresponding footswitch LED will glow orange to
indicate Overdub.
Pressing the loop footswitch
during an overdub will
close that over-
dub
.
After closing an overdub you can choose to reopen it by pressing the
loop footswitch
−
as long as the loop cycle hasn’t ended yet
. At the
end of the loop cycle, all audio recorded during that cycle is merged
and saved as a single overdub.
Pressing Stop
in the middle of an overdub will cancel that overdub
and
eliminate the dubbed audio
.
For instructions on how to Undo and Redo overdubs, please see Re-
mote Switch Functions, page 33.
