11
4. Control elements
5. First set-up
The transmitter requires a CR2025 battery for operation. There is
a LED at the top of the remote that confi rms each operation. If the
brightness or range of the remote control decreases, the
battery must be replaced.
Proceed as follows:
• To insert the cell, lever open the lid with a coin on the recess.
• Carefully insert the button cell into the holder with the plus pole
facing up.
• Place the metal bracket back into the bottom of the housing and
join the two halves of the housing together.
6. Connections on the receiver
ATTENTION: The correct polarity of the supply voltage must be
observed. The existing cables are connected via a screw terminal.
So that the receiver can receive the signals from the transmitter,
it must be connected to the appropriate transmitter. This
is done by a simple channel selection via a DIP turn switch.
35040-90-7000.indd 11
19.08.19 08:43
