Engine Oil Temp
Engine Oil Temp
3-6-07
On ground:
1.
Oil................................................
Check OIL T °C indication
If oil temperature is high:
2.
Aircraft.........................................
Position into wind
3.
PCL.............................................
Increase power
If oil temperature does not return to normal:
4.
ELECTRICAL HEAT/COOL
switch..........................................
INHIBIT
If
Engine Oil Temp
or
Engine Oil Temp
remains:
5.
Engine.........................................
Shut down engine. Maintenance required.
If oil temperature is low (below -40 ºC):
6.
Engine.........................................
Do not start. Preheating is required.
If oil temperature is -40 ºC or above:
7.
PCL.............................................
Use low power settings (maximum 72%
NG steady state) until oil temperature is
above 15°C.
--- END ---
In flight:
1.
Oil................................................
Check OIL T ºC indication
If oil temperature is high:
2.
PCL.............................................
Reduce power
If oil temperature does not return to normal:
3.
Landing gear...............................
Extend
If
Engine Oil Temp
or
Engine Oil Temp
remains:
4.
Aircraft.........................................
Land as soon as practical
After landing:
5.
Engine.........................................
Shut down engine. Maintenance required
---------- END -----------
Starter Engaged
3-6-08
On ground (during an engine start):
1.
Engine switch..............................
OFF
Continued on next page
Section 3 - Emergency Procedures (EASA Approved)
Engine Emergencies
Pilot's Operating Handbook
Report No: 02406
Issue date: Mar 06, 2020
Page 3-6-4
12-C-A15-40-0306-00A-141A-A
FOR
GENERAL
AND
FAMILIARIZATION
PURPOSES
ONLY
