3A-7
Smartview
3A-7-1
Smartview Procedures
Smartview abnormal procedures
3A-7-01
If Smartview information is inconsistent with APEX primary flight indications:
1.
PFD.............................................
Select OVRLY menu
2.
SV...............................................
OFF
Note
SV can be set to OFF by deselecting the checkmark “SVS ON”.
3.
PFD.............................................
Verify SV is removed
4.
Aircraft.........................................
Use APEX primary flight indications
--- END ---
If APEX operation in reversionary mode is required due to a DU 1 failure:
Note
If APEX operation in reversionary mode (due to DU 1 or AGM failure), the PFD
format reverts to SV off (blue over brown) and to the default flight director cross
pointer (X-Ptr). After approximately 2.5 minutes the SV is displayed automatically
and the pilot can reselect the preferred flight director mode on the FCS tab.
Example:
−
Indication:
Check DU 1
−
Condition: Pilot PFD is blank or suspect
1.
Reversion Controller...................
Set DU 1 control knob to OFF/REV
2.
Aircraft.........................................
PPFD is shown on upper MFD in SV off
format (blue over brown) and pitch based
X Ptr default flight director is active
After 2.5 minutes:
3.
Aircraft.........................................
SV is automatically re-displayed
4.
Pilot.............................................
Re-select preferred flight director mode
on FCS Tab
---------- END -----------
Section 3A - Abnormal Procedures (EASA Approved)
Smartview
Pilot's Operating Handbook
Report No: 02406
Issue date: Mar 06, 2020
Page 3A-7-1
12-C-A15-48-0307-00A-141U-A
FOR
GENERAL
AND
FAMILIARIZATION
PURPOSES
ONLY
