6-4
Airplane Weighing with Jacks and Load Cells
6-4-1
Leveling
Put the jacks in position below the wing and tail jacking points. The fuselage jacking points
must not be used. Refer to the manufacturer’s instructions for the use of the load cell
equipment. Position the load cells and adapters and slowly raise the aircraft clear of the
ground.
Open the cargo door and place a level across the seat tracks. Place the level along the top of
the inboard seat track and adjust the tail jack until the airplane is longitudinally level. Refer to
Section 8,
of this Handbook for more information concerning airplane leveling.
Remove the level and carefully close the cargo door.
Section 6 - Weight and Balance (EASA Approved)
Airplane Weighing with Jacks and Load Cells
Pilot's Operating Handbook
Report No: 02406
Issue date: Mar 06, 2020
Page 6-4-1
12-C-A15-30-0604-00A-169A-A
FOR
GENERAL
AND
FAMILIARIZATION
PURPOSES
ONLY
