Component Maintenance Manual
EFFECTIVITY: ALL
21-00-22
Page
7005
JULY 21, 2011
9.2.6.7
Secure drive pulley by tightening drive pulley set screws (refer to table 1, section 1.3
for torque specifications).
9.2.6.8
Tighten and secure compressor mounting bolts, washers, and lock nuts (refer to table
1, section 1.3 for torque specifications).
9.2.7
Assembly of Belt Cover
9.2.7.1
Position belt cover on assembly and attach 2 fasteners at lower cover, attach 2
fasteners at upper mid cover just inside belt cover opening. Install 2 mounting bolts
on side of assembly used to secure drive motor (refer to table 1, section 1.3 for
torque specifications).
9.2.8
Assembly of Receiver Dryer
9.2.8.1
Carefully slide receiver dryer into mounting clamp and tighten clamp.
9.2.8.2
Using a wire brush and cleaning solvent, completely remove old thread sealant. Apply
a thin layer of thread sealant primer to fitting threads.
CAUTION
: APPLY THREAD SEALANT SPARINGLY TO MALE FITTING THREADS STAYING CLEAR OF
FIRST 2-3 THREADS.
9.2.8.3
Apply 1-2 drops of thread sealant on receiver dryer inlet port threads.
CAUTION
: TAKE EXTREME CARE NOT TO GET REFRIGERANT OIL ON FITTING THREADS.
9.2.8.4
Apply thin film of refrigerant oil to O-ring and install on condenser fitting.
9.2.8.5
Connect condenser fitting to receiver dryer and tighten (refer to table 1, section 1.3 for
torque specifications).