Attach the Bezels
You must attach all bezels or the system generates an error condition and lights
the FLT LEDs amber.
1 Install all Pilot, Slammer, and Brick bezels as required.
2 For Bricks, at the front of the system, fully seat all drives by pressing each
drive carrier into the Brick chassis.
3 Insert the bottom two hooks on the bezel into the rack rail tabs at the
bottom of the hardware component.
Figure 65 Bezel hook on the right side of the bezel
Legend
1 Insert the bezel hooks into the tabs on each side of the Brick
4 Press the top corners of the bezel to engage the top two bezel hooks with
the top rail tabs.
5 Press both ejector tabs (if open) until they lock in place.
The top hooks should latch with an audible click. If the bezel does not light
when you apply power to the system, verify that the top and bottom hooks
are properly engaged.
Chapter 6 Complete the Installation
Attach the Bezels
130
