See the next figure.
Repeat this step for the other center screw in the front and for the screws at
the back, under the scope hook. The square hole in the front is at the top on
the left side and at the bottom on the right side. These square holes are for
securing the Brick. Use only the round holes to secure the rails into the rack.
Figure 23 2U rack rails installed in rack
Legend
1 Back
2 Front
3 Slider lock nuts
4 Repeat Steps 1 through 3 for the other side rail.
5 Tighten the four slider lock nuts that attach each rail scope to the rail.
Related references
•
Related tasks
•
Install a Brick Storage Enclosure
Chapter 2 Set Up the Rack
About Component Placement
60
