The digit setting of the Brick is visible in the center of the digital push button
and identifies the type of Brick.
2 Verify that the digit setting on the Brick Enclosure Services (ES) module is
set correctly for the Brick before powering on the Brick.
Important! The digit setting for all Bricks (SATA, SSD, and FC RAID) is pre-
set to 0. The digit setting for the FC Expansion Brick is pre-set to 1.
However, the digit setting must always be verified during installation.
Otherwise, the Pillar Axiom 600 system cannot bring the Brick online.
3 If the digit setting is not set correctly, push the button using a sharp object,
such as the end of a paper clip or a small screwdriver to set the Brick ID.
The top button ( - ) decrements the counter and the bottom button ( + )
increments the counter.
Important! Do not change the digit settings while the Brick is powered on.
Related tasks
•
Install a Brick Storage Enclosure
Chapter 3 Install Components
Set the Identity of Bricks
79
