1 Connect a workstation directly to the Pilot management Ethernet to modify
the default IP addresses and interface settings before connecting the Pilot
management interfaces to any network.
2 Attach that workstation to the top Pilot CU0 (PLT-0) and ping 10.0.0.2.
3 If you get a ping response, continue to Step 4. If you do not get a ping
response, attach the workstation to the bottom Pilot CU1 (PLT-1) and retry
the ping.
4 Connect the Pilot CU on which you receive a ping response to the Pillar
Axiom Storage Services Manager.
5 In the left navigation pane, click on the Networking link under Global Settings to
modify the IP addresses of the Pilot so that they are appropriate for your
network.
6 If the customer network requires that auto-negation be disabled, manually
configure the interface speed and duplex setting to match the network.
7 For Pilot CU0 — PLT-0 (the top CU), connect the MGMT port to the
Ethernet LAN that is used for managing the Pillar Axiom system.
Figure 44 Pilot management cables
Note: This image is for illustration purposes only. Your hardware
component might look different.
8 Using a second cable, repeat the above step for Pilot CU1 (PLT-1) (the
bottom CU).
Chapter 4 Connect Data Cables
Connect the Pilot to Your Management LAN
101