Figure 35 Insertion of a Slammer
3 Put a spacer on a 10-32 x 1/2 inch Torx screw, then insert the screw
through the hole in the ear on the left side of the Slammer.
4 Push the Slammer so that its ears and the spacers rest against the vertical
channels, then start the Torx screws with your fingers.
5 Use a #20 Torx wrench to secure the screws to the rack.
Note: This step only keeps the Slammer in place; the screws provide no
other support.
6 Repeat Steps 3 through 5 for the right side of the Slammer.
7 (Pillar Axiom 600 systems only) If you have a two, three, or four Slammer
system, install the remaining Slammers now.
Important! Do not apply power to the Slammers until instructed to do so.
Related references
•
Cable Length Limits for SAN Fibre Channel Connections
Chapter 3 Install Components
Install a Slammer Storage Controller
72
