Install the Slammer Batteries
Slammer batteries are shipped separately.
1 Ensure the
Install Before Date on the Slammer batteries have not expired.
The
Install Before Date is printed on the label on top of the battery. If a
battery is past the
Install Before Date, contact the Pillar World Wide
Customer Support Center.
2 Remove the front cover (bezel).
If the bezel is not attached, skip to Step 5.
3 Press the Slammer ejector tabs on the bezel to unlock them.
4 Lift both ejector tabs to disengage the bezel from the rack.
Figure 36 Slammer bezel removal
Legend
1 Ejector tab
2 Button
3 Disengage the bezel from the rack
5 Insert the batteries into the Slammer, but do not secure them until you
complete the installation.
Tip: When you secure them, they start to discharge as they preserve data
in memory. Because there is no data to preserve, you should wait until you
are ready to power on the system before securing the batteries.
Chapter 3 Install Components
Install the Slammer Batteries
73
