Wing Servo/Flaps Assembly
The control horns are pre-installed at the
factory, ready for use.
1.Screw the servo to the included
aluminium L shaped brackets, then
install the servo arm on to the servo,
making sure that this is centred
2.Place the servo over the servo plate
making sure that the arm moves freely
3.Drill out the four holes in the plate, then
making sure that the arm moves freely
within the provided slot, and mark out
the placement of the four screw holes
3.Drill out the four holes in the plate, then
securely screw the servo to the inside of
the plate using the metal screws
provided
