PILOTAGE NANO-X2, Manual

14

www.pilotage-rc.com

1 . Please do NOT release the throttle lever when flying in the height . Otherwise it may cause the aircraft crashed abruptly 

and cause loss of the parts .

2 . Please do NOT fly this aircraft on the place where there is many obstacles nearby so as not to cause unnecessary loss .

3 . Please keep the aircraft flying about 1 meter away from the ground .

Connect the aircraft with the charging wire, then insert the charging wire into the USB 

port of the computer or any other USB charger . When the USB indicator is ON, that 

represents it is under charging . When the indicator is OFF, that represents it is fully 

charged . Except for Apple charger, this USB charging wire can be connected with 

any other charger of Smart mobile or movable power or being charged on the USB 

interface on the car . the voltage of the USB interface is +5+0 .5V .

The correct starting sequence is as below when switching on the power:

1 . Pull the throttle lever to the lowest point .

2 . Switch on the power of the aircraft, put the aircraft on the level ground and keep static . the indicator of the aircraft will be flashing .

3 . Switch on the power of the transmitter, the transmitter will send out sound of “di, di”, then push the throttle lever to the highest 

(as picture 2 shown), it will send out sound of “di” and then pull the throttle lever to the bottom (as picture 3 shown), that 

represents the decoding has been successfully finished . This time the indicator of the aircraft will stop flashing .

VEHICLE CHARGING

BEGIN TO TAKE OFF

1

1

3

2

2

3