PILOTAGE NANO-X2, Manual

18

www.pilotage-rc.com

NOTE: 

If the aircraft still keeps drifting to one direction, you can put it on a level surface . 

Pad several pieces of paper on the deviating direction (The paper quantity re-

quired is dependent on the drifting extent in order to adjust the deviating angle 

of the accelerometer) .

STUCK PROTECTION AND ACTIVATION

COMMON BREAKDOWN MAINTENANCE OF THE R/C 

QUADROCOPTER

During the course of flying, in the case that it is collided or any other reason which cause jam to the propeller, the battery protecting 

board of the aircraft will power off automatically so as not to cause damaged or danger . Under the condition that the battery 

is fully charged, you can switch off the power and just restart it . If the aircraft is not connected with the power after being restarted, 

it means the battery electricity is not enough to activate the battery . This time you can use the original USB charging wire made 

in our factory to connect with the power and then simply activate it .

Troubleshooting

Repair method

The main rotor won’t 

be rotating/ deviate 

when taking off

Reload the batteries inside the aircraft and make decoding once again . If this 

problem still can not be solved, please check if the propeller or rotor is deformed 

or not . if it is severely deformed, please replace it accordingly .

It can not take off

If there is insufficient power with the aircraft, please recharge it . If the problem still 

can not be settled, please kindly calibrate it correctly by following the (accelerator 

calibration) written in the instruction manual .

4 .  Push the Ascending& Descending /steering rudder to the left up corner, push the throttle/aileron control lever to the left down corner, this 

time the indicator of the aircraft will be flashing for 1–2 seconds, that represents the calibration is successfully finished (right-hand throttle) .