P2HZ X4P
Operating Manual P2HZ X4P
20076-EN-08
5
INFORMATION
This gives advice on applications and provides information on special fea-
tures.
Safety
Intended use
The two-hand control relay P2HZ X4P meets the requirements of EN 574 Type III C. It
forces a press operator to keep his hands out of the hazardous area during the dangerous
closing movement, so avoiding hand injuries.
The P2HZ X4P is suitable for use on controllers for metalworking presses as a block for
simultaneity.
The device can be used as a hand protection device in accordance with the following tech-
nical regulations:
}
Mechanical presses (EN 692)
}
Hydraulic presses (EN 693)
Or safety circuits in accordance with EN 60204-1; VDE 0113-1.
The supply voltage for the two-hand control relay must only be connected downstream of
the shutdown device in accordance with § 9 VBG 7n5.1/2.
The following is deemed improper use in particular
}
Any component, technical or electrical modification to the product,
}
Use of the product outside the areas described in this manual,
}
Use of the product outside the technical details (see
NOTICE
EMC-compliant electrical installation
The product is designed for use in an industrial environment. The product
may cause interference if installed in other environments. If installed in other
environments, measures should be taken to comply with the applicable
standards and directives for the respective installation site with regard to in-
terference.
Safety regulations
Safety assessment
Before using a device it is necessary to perform a safety assessment in accordance with
the Machinery Directive.
