Installation
Operating Manual PMCprimo MC
1003813-EN-03
| 28
5.4
Installing the fieldbus junction box
To network a PMCprimo MC
via CANopen, PROFIBUS DP you need a fieldbus junction
box. This is available as an accessory. The fieldbus junction box is plugged into the servo
amplifier.
INFORMATION
Pin assignment, wiring and assembly are described in the operating manual
for the fieldbus junction box.
To install the fieldbus junction box, follow the instructions below:
}
Switch off the mains voltages and 24 V supply.
}
Connect the 9-pin female D-Sub connector X6D to the male connector X6 on the servo
amplifier.
}
Turn the screws into the thread on the housing.
Fig.: Installing the fieldbus junction box on a servo amplifier
