Commissioning
Operating Manual PMCprimo MC
1003813-EN-03
| 52
7.2.5
Operate PMCprimo MC HW1 - Show Hardware
You can operate the motion controller in the commissioning software terminal by issuing
commands in the command language.
HW1 - Show Hardware
0.1: hw1
0.1:
SOFTWARE
Firmware:
03.05.01, Oct 15 2018, 09:01:35
Motion:
INSTALLED
IEC PLC:
INSTALLED
Interpolation: INSTALLED
ETHERNET
IP address
192.168.0.11
Netmask
255.255.255.0
Gateway
192.168.0.1
CHANNELS
Number
1...32
HARDWARE
Type:
PMCprimo MC 1300MHz 4xCAN
Item No.:
680080
Ser. No.:
100033
Pr. Ver.:
1.0
Encoder:
3
Inputs:
16
Outputs:
16
Virtual in-
puts:
56
Virtual out-
puts:
56
Analogue in-
puts:
0
Analogue Out-
puts:
0
DEVICES in CAN Network:
PMCtendo DD4 (SD01) at CAN4 ADDR 6 found (DS402)
Inputs:
2
