Safety
Operating Manual PNOZ m B0
1002660-EN-07
10
3
Safety
3.1
Intended use
The configurable system PNOZmulti 2 is used for the safety-related interruption of safety
circuits and is designed for use in:
}
Emergency stop equipment
}
Safety circuits in accordance with VDE 0113 Part 1 and EN 60204-1
CAUTION!
Inputs and outputs for standard functions must not be used for safety-re-
lated applications.
}
The product PNOZ m B0 meets the requirements of the standards EN 81-20, EN 81-22
and EN 81-50, harmonised under the Lifts Directive 2014/33/EU, and the requirements
of the standard EN 115-1, harmonised under the Machinery Directive 2006/42/EC.
}
The programmable safety system should be installed in a protected environment that
meets at least the requirements of pollution degree 2.
Example: Protected inside space or control cabinet with protection type IP54 and cor-
responding air conditioning.
The following is deemed improper use in particular
}
Any component, technical or electrical modification to the product,
}
Use of the product outside the areas described in this manual,
}
Use of the product outside the technical details (see
NOTICE
EMC-compliant electrical installation
The product is designed for use in an industrial environment. The product
may cause interference if installed in other environments. If installed in other
environments, measures should be taken to comply with the applicable
standards and directives for the respective installation site with regard to in-
terference.
3.2
System requirements
Please refer to the "Product Modifications" document in the "Version overview" section for
details of which versions of the PNOZmulti Configurator can be used for this product.
3.3
Safety regulations
3.3.1
Safety assessment
Before using a device it is necessary to perform a safety assessment in accordance with
the Machinery Directive.
