PNOZ m ES Profibus
Operating Manual PNOZ m ES Profibus
1002698EN04
9
Disposal
}
In safetyrelated applications, please comply with the mission time t
M
in the safetyre
lated characteristic data.
}
When decommissioning, please comply with local regulations regarding the disposal of
electronic devices (e.g. Electrical and Electronic Equipment Act).
For your safety
The unit meets all necessary conditions for safe operation. However, you should always en
sure that the following safety requirements are met:
}
This operating manual only describes the basic functions of the unit. Information on the
advanced functions can be found in the online help for the PNOZmulti Configurator and
in the PNOZmulti technical catalogue. Only use these functions after you have read and
understood the documentation. All necessary documentation can be found on the
PNOZmulti Configurator CD.
}
Do not open the housing or make any unauthorised modifications.
}
Please make sure you shut down the supply voltage when performing maintenance
work (e.g. exchanging contactors).
Function description
Operation
The virtual inputs and outputs that are to be transferred via PROFIBUS are selected and
configured in the PNOZmulti Configurator. The base unit and the expansion modulePNOZ
m ES Profibus are connected via a jumper.
The station address is set via rotary switches. After the supply voltage is switched on or the
control system PNOZmulti 2 is reset, the expansion module PNOZ m ES Profibus is con
figured and started automatically.
LEDs indicate the status of the expansion module on PROFIBUS.
The configuration is described in detail in the PNOZmulti Configurator's online help.
INFORMATION
The GSD file is available on the Internet at www.pilz.de.
Data access
The data is structured as follows:
}
Virtual data
–
Input range PNOZ m ES Profibus
The values for the inputs are set as an output in the Master and transferred to the
PNOZmulti 2.
–
Output range PNOZ m ES Profibus
