Safety
Operating Manual PNOZ mmc7p CC
1003066EN02
8
3
Safety
3.1
Intended use
The fieldbus module PNOZ mmc7p CC is an expansion module of the configurable control
system PNOZmulti. It is used for communication between the configurable control system
PNOZmulti and the CCLink .
CCLink is designed for fast data exchange at field level. The expansion module CCLink is
a passive subscriber (Slave) in CCLink. The basic communication functions with CCLink
conform to CCLink V1.10. The central controller (master) reads input information from the
slaves and writes output information to the slaves as part of each cycle. As well as the cyc
lical transfer of usable data, the expansion module PNOZ mmc7p CC also has diagnostic
and commissioning functions. Data traffic is monitored on the Master/Slave side.
The expansion module may only be connected to a base unit from the configurable control
system PNOZmulti (please refer to the document "PNOZmulti System Expansion" for de
tails of the base units that can be connected)
The configurable control system PNOZmulti is used for the safetyrelated interruption of
safety circuits and is designed for use in:
}
ESTOP equipment
}
Safety circuits in accordance with VDE 0113 Part 1 and EN 602041
The expansion module may not be used for safetyrelated functions.
The following is deemed improper use in particular:
}
Any component, technical or electrical modification to the product
}
Use of the product outside the areas described in this manual
}
Use of the product outside the technical details (see chapter entitled "Technical De
tails").
NOTICE
EMCcompliant electrical installation
The product is designed for use in an industrial environment. The product
may cause interference if installed in other environments. If installed in other
environments, measures should be taken to comply with the applicable
standards and directives for the respective installation site with regard to in
terference.
3.2
System requirements
Please refer to the "Product Modifications" document in the "Version overview" section for
details of which versions of the base unit and PNOZmulti Configurator can be used for this
product.
