Installation
Installation Manual PNOZmulti Installation Manual
1002265-EN-02
18
4.2
Install the control system PNOZmulti
4.2.1
Install base unit without expansion module
When installed on its own, a base unit from the configurable control system PNOZmulti
must be fitted with a terminator:
}
The terminator must be fitted to the side of the base unit marked “Termination/Link”.
}
Do not fit a terminator on the left hand side of the base unit.
Terminator
Termination/Link
4.2.2
Connect the base unit and expansion modules
The modules are linked via jumpers.
There are 2 pin connectors on the rear of the base unit.
}
Make sure that no terminator is fitted.
}
Connect the base unit, expansion modules and fieldbus module using the jumpers sup-
plied.
}
The terminator must be fitted to the last expansion module to the right of the base unit.
}
A terminator must not be fitted to the last expansion module to the left of the base unit.
Expansion module 1 ... 8
Jumpers
Terminator
Fieldbus module
Base unit
Expansion module 1 ... 4
Power supply
