Installation and alignment
Operating Manual PSEN sc L 3/5 series
1005056-EN-01
| 55
7.4
Installation with setting of angle of inclination/roll angle -
bracket PSEN sc bracket PR
}
The setting of the angle of inclination of the safety laser scanner is not changed when ex-
changing the safety laser scanner.
Prerequisites
}
Mounting surface with 2 drill holes, 10 mm deep, distance 73 mm horizontally towards
each other for fixing the PSEN sc bracket PR or PSEN sc bracket P
}
The protective bracket PSEN sc bracket H must already be fixed at the safety laser scan-
ner (see
Installation of the protective bracket PSEN sc bracket H at the safety laser
).
[5]
[7]
[6]
[8]
[1]
[2]
[3]
[4]
[4]
[3]
[7]
Legend
[1] Adjusting disc for angle of inclination
[2] Set screw for adjusting disc for angle of inclination
[3] Fixing screws for safety laser scanner
[4] Fine adjustment screws for the incline of the safety laser scanner
[5] Front part of the PSEN sc bracket PR
[6] Fixing screws for fixing to the mounting surface
[7] Roll angle fine adjustment screws
[8] Rear part of the PSEN sc bracket PR
Procedure:
1. Loosen the roll angle fine adjustment screws [7] of PSEN sc bracket PR slightly, if re-
quired, and align the front part [5] of PSEN sc bracket PR to the rear part [8].
The bracket is pre-assembled.
2. Fix PSEN sc bracket PR with the fixing screws [6] to the mounting surface and tighten
the fixing screws [6] alternately and evenly with 3 Nm.
3. Fix the adjusting disc for angle of inclination [1] with the set screw and washers [2] at
PSEN sc bracket P (right or left).
4. Align the middle of the adjusting disc for angle of inclination [1] with the center of the fix-
ing for the safety laser scanner [3] and tighten the set screw for the adjusting disc for
angle of inclination [2] with 2,5 Nm.
