User manual RXN-406 Keypad for CAPTAIN-i Alarm System
3
SAFETY INSTRUCTIONS
Your CAPTAIN-i alarm system has been registered in accordance with EN60950 and its
rules. EN 60950 requires us to advise you the following information:
1. In this alarm system exists hazards of fire and electric shock
.
To reduce the risk of fire
or electric shock, do not expose this alarm system to rain or moisture. Pay attention:
Telephone cords could be a good conductor for lightings energy.
2. Do not open the door of the alarm system. Dangerous high voltages are present inside
of the enclosure. Refer servicing to qualified personnel only.
3. This alarm system should be used with AC 230V50Hz, protected by anti electric
shock breaker. To prevent electric shocks and fire hazards, do NOT use any other
power source.
4. Do not spill liquid of any kind onto the unit. If liquid is accidentally spilled onto the
unit, immediately consult a qualified service.
5. Install this product in a protected location where no one can trip over any line or
power cord. Protect cords from damage or abrasion.
6. Disconnect all sources of power supply before proceeding with the installation. Pay
attention: do not install low voltage wires near by AC power wires they should be
separated.
7. Connect the AC transformer output to the terminal block on the control panel as
marked.
8. Connect the AC line cord to line power terminals as marked. (GND; N; L)
